Beskar RPI Zero Case

Rendering: DarkUp

We’ve been wanting to share this design now for weeks, our case is a beskar ingot with damascus print on top. Not all printers are capable of printing the pattern. We’ve been succesfull on the Creality CR6se, the Formbot Raptor and on the Dagoma Neva. The Creality Ender2 did not print the pattern, not even on 0.12mm layerheight.

Our Cura Settings :
– Layerheight : Dynamic 0.16
– Printspeed : 50mm/s
– Infill : 17%
– PLA tested and PETG tested
– Support : Yes, we were only succesfull with the damascus print to the top and a lot of support underneath.

Leave a Reply

Your email address will not be published. Required fields are marked *